Carpenter – Fourth Period

A ____ truss allows for full insulation at the perimeter.

To be eligible for R-2000 certification, air changes per hour (ACH) are required to be ____ or lower.

To be eligible for ____ certification, air changes per hour (ACH) are required to be 1.5 or lower.

A standard toilet will typically occupy ____ mm of space.

A standard ____ will typically occupy 750 mm of space.

Advanced framing is a method of framing a house that ____.

What is the recommended space that should be left above insulation in a bay window to keep a house warm?

A recommended space of 25 – 50 mm should be left ____ in a bay window to help keep a house warm.

Many jurisdictions do not permit supply only exhaust systems because they ____.

It is estimated that ____% of the population suffer from some form of an allergy.

It is estimated that 20% of the population suffer from ____.

Foundations must be able to be drilled for dowels, take rods and bolts when building an addition that ____.

Caulking that is ____ should never be used on builds for people who are hypersensitive to chemicals.

Measuring and laying out should be done with the backside of ____.

On a light duty scaffold, planks and platforms must not span more than ____ metres.

On a ____, planks and platforms must not span more than 3.1 metres.

Which of the following are characteristics of pre-manufactured wall panels. Select all that apply (4/5)

____ come in blueprint-matched, full widths, selectively reduced widths and sequence-matched uniform size set varieties.

When installing ____, it is common to place wooden strips between the flooring and the concrete.

Class D fire extinguishers should be located near ____.

The forefinger pointing up and rotating the hand in a circular motion best describes the ____ signal.

A non-grain raising stain has the following characteristics. Select all that apply (2/5)

Particle board, MDF, plywood and solid laminated wood are ____.

____ are fastened with glue to the frame and fasteners are placed in the top and bottom.

A baseboard should be mitred at ____ degree on an inside 90 degree corner.

A baseboard should be mitred at 44 degree on a(n) ____.

A standard space of ____ mm needs to be left open when installing a trash compactor in a cabinet.

A standard space of 306 mm needs to be left open when installing a(n) ____ in a cabinet.

Brushing on enough mineral spirits to wet a wooden surface is a good way to detect if any ____ is present.

When fastening trim, nails must be long enough to do the following. Select all that apply (3/5)

When fastening material into a wall stud the fastener should penetrate ____ the thickness of the material being fastened.

A journeyman carpenter can join the ____ program to be eligible to work their trade in other provinces.