Steamfitter/Pipefitter Exam – First Period

The valence shell is part of the outermost shell of a(n) ____.

How would you express 0.0055 as a percentage?

Matter is any object that ____ and has ____.

Which of the following is NOT a state of matter?

An atom’s valence shell is located in the ____.

0.0055 expressed as a percentage is what?

Matter is anything that occupies which of the following? Select all that apply (2/5)

What are some examples of matter? Select all that apply (2/5)

The ‘notes’ section of blueprints can convey what sort of information?

Looking at a process line to find the piping class & line class number; what type of drawing would be your first choice?

What can you find in the notes section of a blueprint drawing?

When preheating pipe for welding and for post weld heat treatment which of the following would be an appropriate gas to use?

The fusible plug installed on an acetylene cylinder is designed to ____ at approximately 100 °C (212 °F).

A bourdon tube is a component of which device for the correct operation of the regulator gauge indicator needle?

____ is an alternative fuel gas you would use for preheat and post weld heat treatment.

In the event of exposure to elevated temperatures such as a fire, a(n) ____ will melt on a acetylene cylinder.

In a(n) ____ you would you find a bourdon tube installed for operation of the indicator needle.

Muriatic or Hydrochloric acid is the choice solder flux for the following metal.

Under plumbing regulations, yellow is the only acceptable solvent color for which product?

____ % of torque is applied to the nut for a tension ‘preload’.

Muriatic or hydrochloric solder flux is used with which type of metal?

Plumbing regulations state that ____ must be yellow in colour.

Plumbing regulations require acrylonitrile butadiene styrene plastic solvent cement to be which color?

Ten percent of the torque applied to a nut on a stud, transfers in ____ on the nut.

Preload tension on the nut occurs when ____ of torque is applied on the nut.

It is important to follow ____ steps to correctly don a full body safety harness.

Under CSA Standard Z94.3-15: Eye and Face Protectors; Welding helmets are grouped in which class?

When donning a ____ in a safe and proper manner, there are five steps to be followed.

There are ____ steps to putting on a full body harness in a safe and proper manner.

With regards to PPE, CSA Class 3 includes ____.

Welding helmets fall under Class ____ of CSA eye protection.

Requiring employees wear safety glasses would be an example of using ____, to control a hazard.

Wearing safety eyewear is an example of which type of hazard controls?